Home Improvement

Thoughts & Stuff I Like When We Redid Our House

Paint Spray

Fix your "spitting" paint spray gun!

@font-face { font-family: "Cambria"; }p.MsoNormal, li.MsoNormal, div.MsoNormal { margin: 0in 0in 0.0001pt; font-size: 12pt; font-family: "Times New Roman"; }div.Section1 { page: Section1; }div.Section2 { page: Section2; }

During these tough economy times, good value at affordable pricing is a very important aspect for operating a successful business. The EZ Packing Replacement Seat is a revolutionary way to enhance the performance of a "new packing kit", but most importantly, fixes a "spitting" paint gun immediately in the field and can be installed in 2 minutes or less.

Joe Simms, a professional painter himself, has been painting for over 20 years in Tucson, Arizona. In 2000, Joe became frustrated when his gun began to spit in the middle of painting doors with acrylic water-based paint.  While this happens to every professional painter in the world, he began to think of ways to fix this problem while on the job just so he could finish the day's work and go home. "There's nothing worse than a spitting gun in the middle or near the end of a hard day's job. Especially when you only have one gun to work with", says Joe.  In 2000, Joe began searching for ways to prevent and fix spitting guns from his home shop.  "The reason for a spitting gun is that you have a metal needle striking a metal diffuser nut.  If your straining techniques are not clean and consistent, debris will pit the needle causing it to spit." Joe adds.  A simple solution to the problem was to have a metal needle strike a specially designed nylon seat. Now you have metal striking nylon.  Ten years later, Joe had the design and patent for his EZ Packing Replacement Packing Seat, his answer to fix this problem in the field. EZ Packing, for short, is a revolutionary nylon seat that fits snug inside the diffuser nut of professional Graco, Titan and Airlessco spray guns and can be used in conjunction with a new packing application and/or an existing or spitting needle.  Tests have proven EZ Packing will allow up to an additional 500 gallons of paint sprayed before the gun needs to be repacked.  EZ Packing will prolong the life of a new needle and we recommend installing one before spraying begins.

For more information and video demos, please log onto www.jbsproductline.com

Benefits:

Stops spray gun "Spitting"

No down time

Easy to install

Installed in the field

Takes less than 2 minutes to install

Saves money -25% of a "New Packing Kit"

Easy storage

Dramatically prolongs the life of a new needle

Gets the painter through the day

Does what we say it will do

Fits:

Graco Contractor

Graco Silver Plus

Graco Silver

G-10

Titan SGX-20 or SL-80

Graco 18-Volt Unit

About the Author

What causes spray paint for plastic to separate and form small pits on plastic dash parts?

Im using Valspar Spray Paint made for plastic. Im spraying it on a 2002 Honda Accord ex. Thanks!

the surface probably wasn't clean enough,if there was any old armor all or any other chemicals on it that will cause it to do that,what you have to do is clean it really good and then wipe it down with alcohol before you paint it,and don't paint it if its hot or in the sun that too will cause it to separate on it,if the surface is really clean on it,it should go on and look really good,good luck with it.

Spray Paint Art Paradisio